Title:  Verification and Control Inspector-Bending

Verification and Control Inspector-Bending 

LOCATION: Dammam - Eastern Province  - Saudi Arabia 

DEPARTMENT:  QUALITY 

HR CONTACT: Cely Varela

Verification and Control Inspector- Bending

Responsibilities:

Performs the verifications and/or final inspections as applicable. 

• Performs the verifications and/or final inspections as requested.
• Reports results of the verifications and/or inspections performed.
• Supports manufacturing areas on technical matters as required.
• Evaluates the effectiveness of the corrective and preventive action taken as part of a quality event.
• Detects and reports any HSE deviation or risk observed during his/her activities.
• Acts as a reference in terms of process and product Quality. 
• Proposes solutions to problems or risks detected and follows up and evaluates the effectivenes of the corrective and preventive action taken.
• Performs product/process/system audits as requested.

Profile experience expectations:

• Good metallurgical basic knowledge and mechanical testing
• Heat treatment experience
• Experience defining parameters for heat treatments
• Knowledge and experience of verification and documentation and report writing.
• Experience, knowledge in induction bending.
• Excellent communication skills in English
• Bachelor in Metallurgy or Mechanical Engineering.

If you are interested in this position and your experience and knowledge match our requirements, please apply, or contact your local HR representative for more information.

Thank you for your interest.

 Visit our Careers Page

Follow us on LinkedIn

Follow us on Glassdoor

Like us on Facebook

Follow us on Instagram